Thermograpgh

JTS ENERGY will carry out energy conservation surveys using thermal imaging camera to detect wasted energy through poor insulation of buildings, pipe work, boilers and hot water storage tanks, the surveys will also highlight cold spots through silting and the over heating of cables, control panels and motors.

......
Fuse Overheatin ........Un-insulated Pipes ...Over Heated Motor

JTS ENERGY will also calculate the kW of wasted energy through heat loss and also show how you can save energy and give advice on energy saving equipment such as motor and lighting controls.

JTS ENERGY can include in our surveys the following:

Power Factor correction equipment checks
Harmonic Checks
Air Leak Detection
Thermal ingress from sunlight
Thermal ingress into cold storage areas
Advice on using excess heat and heat from compressors to heat buildings and water
Advice on pipe work, gate valves insulation
Landfill Site Surveys for underground fires

JTS ENERGY carry out energy surveys combining thermal imaging and will give you the total waste of energy that not turning off equipment when not needed will cost you, but JTS ENERGY takes this advice a step further by showing you what effect this is having on your fuses and wiring that will cause overheating and can cause a fire hazard. Insurance companies are starting to insist that this information be recorded. We convert the temperature to kW and give the monetary loss as well.

Every one knows that they should turn off equipment and that it is expensive not to do so but Your staff very often forget or don’t bother to switch items off at night or when leaving their work stations. What they do not see is the consequences for not turning off unwanted equipment or adding equipment such as heaters and fans without checking that the wiring and fuses can take the extra loading.

Poor insulation of pipe work and buildings are also a great waste of energy and companies do not relate heat loss to kWh and the effect it has on their Gas and Electricity bills. JTS Energy will calculate for you what this waste of energy is in kWh and give you advice on how to reduce this loss and help you to reduce your overheads and carbon emissions in line with government guide lines.

We will give you the calculations in a summary format showing you the following information:

Example:

Area	Description	Temp oc	kWh p.a	Co2	Cost
Comp 1	Use hot air from compressor	73.7	1917.41	0.82	123.48
Office to	Window open	30.3	788.30	0.34	50.76
Wiring	Overheating of wiring to comp	28.7	746.67	0.32	48.08
Ducting	Ducting from Cooling tower	31.8	827.32	0.35	53.28
Office	Ingress of heat through window	48.3	1256.59	0.54	80.92
Boilers	Un-insulated Gate Valves	64.7	1683.26	0.72	108.40
Boilers	An array of 7 gate valves @64.5 each	451.5	11746.44	5.05	756.47

Note: Items marked in red should be calculated by surface area , length or by number of units to be insulated.

JTS ENERGY will give you a full comprehensive site report showing the waste
of energy through heat emissions from equipment, pipe work, buildings and show the waste of energy from equipment not being controlled in the most efficient way plus a comprehensive lighting report showing the loss of energy through poor lighting and lighting controls so as to help you reduce your utility overheads and increase your companies bottom line.

We will give you the calculations in a summary format showing you the following information:
Example:

Note: Items marked in red should be calculated by surface area , length or by number of units to be insulated.